How to fill the tank and insert a pad Roomba® Combo j7+/j9+

Use the following procedure to get your Roomba® Combo j7+/j9+ ready for a mopping job.

1. Lift the mopping pad plate and slide a mopping pad into the slot.
2. Push the bin release button to remove the bin.
3. Open the cap on the top of the tank.
4. Fill the tank to the top with an approved cleaning solution.
5. Close the cap, then shake out excess solution.
6. Slide the tank back into the robot, and then you’re done.

For help with your Roomba Combo 10 max, please see ”Mopping with Your Roomba® Combo 10 Max”

Note: You do not have to dispose your mopping pad after each mission. The pads for the Roomba Combo j7+/j9+ are washable.

Note: The Roomba® Combo j9+ water tank can hold 170 mL of liquid. If the low liquid amount setting is enabled, the robot could mop up to 1,000 square feet before needing to refill at the dock.

Use the following procedure to clean the pad on the Roomba Combo j7+ or j9+